The clutch and everything has maybe 10 miles on it.
2000 saab breaks going to floor but breaks.
I have a 2000 saab 9 3 convertible.
Initially you will see small air bubbles in the line.
There s some travel before the car starts braking.
If they bled good and the pedal still goes to the floor you need to check the brake master.
On 7 4 09 and 7 6 09 started car and backed out of garage and had no brakes.
I do not go into replacing the emergency brake system as my shoes were not worn out.
I can still brake but all travel has disappeared and you have to apply a bit more force for the brake to.
I still have brake pressure though.
Dealer replaced hydraulic unit master cylinder problem still exists.
New brake pads 2.
However based on past complaints that i have seen on this web site i feel that it is time to address this issue before someone gets injured.
60000 mi us 275.
Used e brake to prevent car from going into street.
Took over 3 weeks to find a new one 300 mi away.
Close the bleeder valve before the pedal reaches the floor.
2007 saab 9 3 aero v 6 engine.
Spongy brakes pedal goes almost to floor.
Gm says all 6 cyl saabs 207 and newer will have this hose fail.
But as i continue to drive and use the brake the pressure increases until it s entirely hard.
6mm hex wrench 4.
2000 saab 9 3 brakes are dragging after vehicle warms up.
However brakes still lock up seize drag while driving.
Bad brake vac hose going to vac pump.
Reported to saab customer service no response.
Straight edge screwdriver 7.
3 8 or 10mm 17mm 19mm or e 20 torx for 2002 and newer 9 5 s 2.
I am thinking that it is in the slave cylinder.
For tools you will need.
Brakes seemed to work fine after that.
Torque wrench for parts you will need.
Maybe something was not put back together right.
When the car starts the brake pressure feels normal.
As brake fluid flows through the clear plastic tube the assistant will notice the brake pedal falling towards the floor.
2005 saab 9 3 arc convertible.
The pedal went right to the floor.
See all problems of the 2005 saab 9 3.
Replaced the master cylinder as the old one was difficult to push in actuate during bench bleeding and wouldn t retract easily.
T30 torx socket 3.
