Snap the two halves of your dodge ram key fob battery back together.
2010 dodge ram 1500 key fob reset.
Press and release the button five times within ten seconds.
Easy peasy repair and replace no programming needed if circuit board is not damaged.
You should hear it unlock.
Click unlock on the fob that s in the ignition.
Insert first programmed key into ignition and turn ignition switch to on for 5 seconds.
Take the following steps to replace your chrysler dodge jeep or ram key fob battery.
You must do this within 15 seconds of removing first key.
Enter your dodge ram 1500 and close the doors and trunk of your vehicle.
Remove metal key from fob.
Step 2 insert your dodge ram 1500 key into your car s ignition and click the key to the on position.
Turn vehicle off and turn hazards off unless you want to drain your battery.
Turn ignition to the on position for at least three 3 to fifteen 15 seconds.
Once a key fob is programmed to a vehicle it can t be reprogrammed to another vehicle.
Hold the lock on the fob for 5 sec.
Insert new cr2032 battery.
Gently remove dead ram key fob battery.
Insert a flat edged tool like a screwdriver into the gap.
Pry the two sections apart.
But i did read a post awhile ago that said it is now possible but haven t verified it as true.
Apr 2 2018 at 8 30 am 3.
Turn ignition switch to off and remove key.
Insert the first working fobik remote key into ignition.
Insert second programmed key into ignition and turn ignition switch to on.
Turn on ignition switch to on position engine off repeatedly press vechicle information button until press to relearn remote key is displayed press set reset button until remote key learning active is displayed.
Procedure 2 ram 1500 fobik remotes step by step how to programming instructions.
Now put the key fob into ignition and turn to on position.
Press the lock button on the remote with your left hand.
Do not exceed 15 seconds.
You would have to check with a dealership or a local locksmith to see if it is possible.